Subject: Taking the Ross apart.
From: Paul
Date: 11/14/2000, 3:58 PM


     Wrathall Mark wrote:
     >
     > Art wrote>

     > >  I have just finished redoing one for Greg Rector of Merritt Island, Fl. I
     > made a new housing, and installed two tapered bearings back to back for the
     > thrust, the main reason for this was the fact that this one was used on a
     > pusher, I also machined the inside of the bell housing where the drive bolts
     > to it, then I made a housing for a thrust bearing and bolted it on there, I
     > used a ball thrust bearing with a little preload for the sun gear, looks
     > like it should do a good job, will let you know as soon as I can, I am
     > taking it to him tommorow so he can put it on and try it out.
     >
     > Do you have drawings or photos you could share of this new configuration
     > Art?
     > Mark Wrathall

     Sorry Mark, I was going to take some, but I was to pressed for time and didn't get to,

     the fellow that is installing it said that he was going to take some, maybe I can get some frome him to show you

     Art


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org