Paul wrote:
I really hate to see this happen. Andy has 400 hours on his plugs up 13B
powered
Christavia and the engine seized due to lack of oil pressure...
SNIP
It would be wise to drill the heads of these bolts and safety wire them in
any installation. Perhaps when Andy removed the engine to send it back
to Dave Atkins for inspection he removed these bolts and did not notice
they
were loose.
Paul Lamar
Ed Anderson wrote:
Paul,
Good suggestion on the oil pick up bolts. Also, another possible
failure mode at least in Andy's set up was the use of what appeared to be a
hose as the pickup tube running from the block approx 10-12" to the bottom
of his external oil sump. When I had a turbocharger on a Honda Civic
(1976), I was using a stainless steel braid rubber hose to feed oil to the
turbo. Heat and age caused cracks to appear in the rubber which quite
readily leaked oil. As you point out it would not take much of a leak in
the pickup tube to lose suction and hence oil pressure.
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org