Subject: Book of the month. Ducted fans
From: Paul
Date: 11/15/2000, 11:31 PM

This is an excellent summary of the problems of applying ducted
fans to low power general aviation airplanes from the book  
"Jet Engines Fundamentals of Theory Design and Operation"
by Klaus Hunecke. Page 50.

The problems were more difficult in the early days of jet engines
as the thrust to weight ratio was not as favorable as it is today. 

As I said before it is going to take some kind of really effective
variable intake duct geometry to make ducted fans work well over the speed
range for relatively low powered light aircraft.

Paul Lamar

 
 "However beneficial a thin intake is for high speed cruising flight,
  performance at take-off or even low-speed flight will be greatly
  degraded.  Due to an alteration of the streamline pattern at these off-
  design flight phases, the strong curvature at the sharp nose will cause
  the flow to separate at the interior part of the intake lip.  Appropriate
  design measures must be applied to prevent flow separation in these
  critical phases of flight, even at the expense of a reduced high-speed
  performance.
    One of these measures calls for an increase of intake cross-section
  the better to match engine airflow demand at low-speed high-thrust
  engine settings.  However, high-speed performance will inevitably be
  compromised.  Additionally, curvature of the intake will have to be
  increased within the intake duct where the flow tends to separate.  If not
  done correctly, sonic velocity may be reached by the intake flow at the
  'throat' where the cross-section is smallest, causing blockage (the
  blockage effect is further discussed in the nozzle chapter).
    Another measure which has proven effective, particularly with
  sharp-nosed high-speed intakes, was the introduction of additional
  secondary intake ducts that open at high-thrust, low-speed or take-off
  conditions.  Driven by a pressure differential between intake duct and
  external flow, a number of spring-operated doors around the intake
  cowl open inward to give passage into secondary flow ducts which
  serve to increase the effective intake cross-section and, hence, the
  airflow.  At the same time, flow through the main intake cross-section
  is reduced, with the additional benefit of preventing the primary
  airstream from attaining excess velocities. (This measure is no longer
  applied to modern commercial transport aircraft because of the
  increased compressor noise escaping through primary and secondary
  intake ducts.)"



The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org