Paul wrote:
I really hate to see this happen. Andy has 400 hours on his plugs up 13B
powered
Christavia and the engine seized due to lack of oil pressure. According
to the Salt
Lake EAA chapter newsletter he has apparently given up on the 13B engine
and bought a Franklin. He is selling his Ross and Warp drive prop.
Andy Venable <avenable@uswest.net>
Supposedly there was nothing wrong with the pump or oil system however
Andy did not disassemble the engine himself so this is third hand
hearsay.
My latest guess on the cause in the absence of any further actual
evidence
is the slightly worn pump merely lost prime as the hot oil drained out of
it when he shut it down for lunch after a cross country flight. Mounting
the engine
plugs up moves the pump up and away from the oil supply. All pumps have
trouble
sucking from a height. Not a good thing for an oil pump. This type of
failure is
unheard of with the rotary engine when mounted upright. The normal pump
mounting is only a few inches at the most from the normal oil level.
This is why the tried and true old Chevy V8 had the pump in the bottom of
the pan submerged in the oil supply. In a case like that priming the pump
is never a problem.
What ever else you do folks if you can't fit the engine in there right
side
up please don't put in a rotary.
Paul Lamar
Here is another possible scenario. These two bolts came loose allowing the
oil pump to suck air and lose prime. This would be aggravated by the plugs
up position causing a longer distance to the oil level and or a change
in the resonant frequency of the oil strainer pickup tube.
It would be wise to drill the heads of these bolts and safety wire them in
any installation. Perhaps when Andy removed the engine to send it back
to Dave Atkins for inspection he removed these bolts and did not notice
they
were loose.
Paul Lamar
Howard wrote:
Paul:
There's no end to the items you can safety wire in an engine.......
They used to consider safety wire or lock tabs a requirement on rods and
mains in piston engines for example. I've been working on engines for
over 20 years and none of the modern ones use safety wire on anything or
lock tabs....... I've never had a bolt come loose on any of these engines.
I would suggest that rather than resort to safety wire and drilling that a
person use blue locktite. It is easy to break loose and works very well.
I actually use it in some situations as a neverseize. It hardens up and
prevents the bolt from coming out by itself, seals out moisture or oil, and
prevents corrosion.
If we start resorting to safety wire on stuff... there's no end to it.
H.W.
Howard
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org