Subject: Hylomar was Whats wrong with this pic.
From: Paul
Date: 11/18/2000, 4:31 PM


snipped

The engine has never run so are the seals reuseable for the reassembly. If
Hylomar was used I would think not??

Ken Gillanders

Ken,
  One of Hylomar's best features is that it never totally sets up and allows a
part coated with it to be removed and reinstalled several times. This feature is
very handy when you need to install a part which may later need to be removed to
install a shim. Since it doesn't harden, it will not plug an oil/coolant
passageway if you go overboard on applying it. Common uses are
To seal an oil pump to the block
Sealing the front and rear camshaft bearing caps. (Otherwise the pressurized oil
will leak between the head and the cap. This will appear to be a leaking cam
seal. Of course, replacing the seal doen't cure the problem)
Anywhere there is a pressurized oil passageway

snipped
To start with, either Hylomar SUCKS or I got a bad tube of it.  The tube was
half empty and it was very firm.  It wouldn't  > flow out unless I heated it in
water first and it wouldn't stick to the parts unless I baked them in the
oven until I almost > couldn't touch them....
Dave Leonard

Dave
 You definitely got a bad tube. Hylomar should be a translucent blue color. It
should be slightly runny in consistancy.

Regarding the Mazda rebuild, the e-shaft was installed backwards.

Charlie Kuss
RV-8A hanging ailerons & flaps
Boca Raton, Fl.


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org