William Adkins wrote:
Paul,
Great news on the O ring. Already ordered 4 .
Any news on the rotor oil seal O rings? Seem to remember
these were also being researched!
Yes been too busy on that. I will try to get this on my list of
things to do. I have one size that fits well but I need to work
out the part numbers. The other size I have is a bit too big so I
need to order another for trial fit.
Paul Lamar
BTW I have cut my intake manifold,bottom piece, from 6 1/2 lbs
to just under 4 lb. Will send pictures when completed.
Fly fast, land slow.
Bill (covered in 2 inches of aluminum shavings)
I also spent some time grinding and shaving a bunch of unnecessary aluminum off my lower intake manifold as a test. Not quite at 4 lbs, yet. though. The main problem seems that the location of the upper flange does not seem ideal for bringing intake runners across the top of the engine (they are too "central"). I still may end up using a lower flange, welding up some short, light 90 degree bends into another flat flange, then going into composite for the rest of the intake runners and dynamic chamber. This would allow the runners to have a much straighter course around the front or back of the engine. I have a interesting sample of an old one done for a turbo (not very pretty) that bonded carbon fiber right to 3" long lower tubes that weighs less than 4 lbs total.
Scott Gettings
I think Tracy still has some six port flanges in stock.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org