Subject: Motor mount parts progress.
From: Paul
Date: 11/19/2000, 5:37 PM

Now that I have the water heater back in, the hangar organized a bit
better, hangar cleaned up after the party and got the 182 back in there I had 
time to do some work on the motor mount parts. Here is a pile of Barry 
rubber bushing 4130 washers I made. Some of the these will be welded to 1 1/2 
inch 4130 tubing to make the motor mount "cups".

Took me awhile to drill these on my lathe until I tried drilling three
at a time. duh! Next step is get some tubing, cut it up in little
pieces and send the works off to Lorin for welding.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

mm-bushing-washers.jpg