Paul wrote:

  Paul,
    I may have missed it being new to the list.What are
the details of your mount plate between engine and drive
unit?(material etc)

  Thanks,
  Kelly Troyer


Dyke Delta/13B Rotary Power

Here are some details. Instead of making two bolt on side pieces as shown here
I will incorporate all this in one big piece of 1/2 inch thick 6061 T6 
aluminum plate replacing Tracy's redrive plate. I have also gone down on the 
size of the tubing welded to the motor mount washers from two inch OD as shown 
here to 1-1/2 inch OD .065 wall just large enough to clear a socket for a 
1/2 inch bolt nut.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org