Subject: Possible 20B turbo exhaust (group) buy?
From: Paul
Date: 11/21/2000, 2:25 AM


A simple close coupled log (Inconel) manifold seems to work very well.
Jeff
Spitzer was considering casting a SS exhaust manifold for a 20B, but I
don't know what happened.
Chuck H


I was looking at casting or hogging out a single piece manifold for turbo
mounting but discovered that it was a bad idea 'cause the differential
expansion (manifold expands much more than engine that it is closely bolted
to) would have caused it to crack unless 1) some form of compliance was
added or 2) it was made beefy enough to slide itself under the bolts.
Either way made the idea no longer attractive and the idea was dropped.
Turns out even a couple of inches of stub pipe from port to log can be
enough to allow for expansion but direct bolting requires about the same
weight as the stock hunk.

Jeff Spitzer

The stock 89-91 hunk is not all that heavy at 16 pounds as I recall.
I think Jeff predicted 19 pounds for his design. The earlier stock 
turbo manifolds crack at the turbo flange and not at the engine flange. I am 
going to use the stock 89-91 hunk as it makes the turbo oil and water plumbing easy.
It is also quite compact. I will just limit TIT to 1400 or 1600 F or so.
If it does not work I can always change it later as the cracks that 
might develop do not appear to be catastrophic.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org