OK Here they are to the best I can measure.
The big dia. one is 4.65 inch ID with a 3/32 inch section size.
AS568A-158 which is 4-3/4 inch ID 3/32 inch section size.
The little dia. one is about 4.35 inch ID with a 1/8 inch section size.
AS56A-245 which is 4-3/8 inch by 1/8 inch section size.
These sizes are not listed directly in the McMaster Carr catalog so you
have to call and give them the AS568A dash part numbers. (562) 692 5911
The picture shows the stock rings, the red teflon encap silicone
o-rings and the teflon O-rings installed in the cast iron oil seals.
The big stock O-ring is black and the small stock O-ring is green.
Using these O-rings your oil temp could go much higher with out losing
your oil seals. These rings are good to 400 F and highly resistant to
all known chemicals you are likely to find in oil or fuel.
What ever you do don't forget to put the spring under the cast iron
oil seal ring or you will never get the ring back out without breaking it.
You will need four of each size for a 13B and six of each size for
a 20B.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org