Subject: Kelly Troyer Dyke Delta
From: Paul
Date: 11/25/2000, 8:33 PM

Kelly,

Tubes A, B, C, D & E can probably be replaced with 3/4 by 1-1/2 inch rectangular
0.049 wall 4130 tubing if six inch long reinforcing patches top and bottom are 
used on all joints. Might save a bit of weight over 1-1/2 OD .065 wall tubing.

Best to make a 1/4 scale model of just the MM tubes out of a 3/4 plywood
firewall and using 3/16 inch square balsa sticks. No need for a scale engine
or scale rubber mounts. The problems I mentioned should become quite
apparent once you apply a little hand pressure on the model.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Kelly-Troyer-mm3.jpg