Subject: Kelly Troyer Dyke Delta
From: Paul
Date: 11/26/2000, 2:38 AM


I foresee another problem with this mount Kelly.
The forward rubber bushings take most of the load
amounting to about 900 pounds down force per side in a six G
pull-up. This would cause the tubing frame around the rear
of the engine to deflect in the direction of the red arrows.
This means that frame is subjected to large local bending loads.
The inner parts of the upper joints are in tension
and the inner parts of the lower joints are in compression.

It is possible for this to work but it is not simple
to analyze for stress and deflection. A computer finite element stress
and deflection program is probably called for here. The other way of
handling it is use the sledge hammer, over kill approach and make those
frame tubes much larger in diameter to take the bending loads. Lets
say about 1-1/2 inch dia. and .065 wall 4130 as a wild ass guess.
You should then monitor the mount frequently for fatigue cracks
in these areas.

The red lines are one suggestion for stabilizing the mount laterally.
There are several other ways of doing it. Another is use one diagonal
in each bay and a cross tube between rubber bushing mounts as I have
already mentioned. These in no way solve the first problem however.

Paul Lamar

  Paul,
    Thanks for the input on the Delta mount. The tubes
for lateral support I left out of the mock-up. I am in
total agreement on them. The deflection of the rear
frame tubes is something I was not smart enough to see.
That is the reason we all need this group of diverse
talents. Will see what I can do to address this problem.

   Thanks,
  Kelly Troyer

--
Dyke Delta/13B Rotary Power

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org