Subject: Mild steel exhaust pipes.
From: Paul
Date: 12/3/2000, 10:36 PM


Paul wrote:

Here is what Tracy's kludged up, temporary, mild steel muffler pipes looked
like
after only a few hours of flying on his way out to Copper State.
Tracy says a thin part of the surface would flake off after each
thermal cycle. Stainless steel if not Inconel is essential for these parts.

Chuck Dunlap wrote:

Y pipes are .100 wall mild steel from Racing Beat. They were flaking a lot at
first but seem to have slowed down a lot now. I have 70 hours on it. I
wonder if the chemistry of the metal is changing. One of my welds cracked at
60 hours and I had to remove and re-weld it.I estimate another 70 hours and
they will be finished and ready for plan B!


Perry Mick wrote:

I have a short, 6 inch pipe, with a 45 degree bend in it.  It is
standard
automotive, made for me at a muffler shop.  It is bolted to the heavy
stock
na exhaust manifold.  It hasn't flaked a bit and still appears to have
the
same wall thickness it started with.  This is because the stock exhaust
manifold is taking all the abuse.

--
Perry J. Mick
Mick Duckt N7XR
http://www.ductedfan.com

You are also down on power Perry. Your max RPM is about 5000 as I recall
due to your direct drive set up. I am sure that helps. I would guess
around 130 HP.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org