Subject: Six pinion planet carrier.
From: Paul
Date: 12/3/2000, 5:47 PM


Here is a picture of John Moran's six pinion planet carrier
taken at Tracy's place on Monday.
This should up the HP capabilities of the the Ford C6 based
psru's by 50%. Roughly 300 HP I would guess. It uses the stock
Ford pinion gears, needle bearings, thrust washers and shafts.

IMHO you will need this if you are installing a 20B three rotor.
This one is designed to be installed in Tracy's redrive but it
would also work in Ross psru's with minor modifications.

In the case of Tracy's redrive another part will also need changing if you
plan
on retrofitting this to an existing redrive.
That was done to lower the manufacturing cost of a new six pinion
redrive.  Tracy tells me he already has a bunch of orders for
six pinion redrives.

Paul Lamar

charles.harbert wrote:

Paul and Tracy, my understanding of planetary drives is that they are "self
aligning" or to some extent "free floating" in order to get equal loading
of each gear. It's very difficult to exactly align the planetary set by
normal machining.  My current Ross drive had to be modified to prevent
uneven wear because of improper alignment. The Ross original style
planetary had cog type teeth restraining the planetary gear holder, but
which allowed it to " self align". Tracy wrote about this in his book I
beliieve.

It appears that you are hard mounting the planetary gear holder. Is this
going to be a problem for gear alignment? It appears to be a pretty heavy
duty arrangement. Will it be incorporated into Tracy's new PSRU?
Chuck

I agree with you Chuck. Tracy and I have had a lot of arguments about this.
Tracy, I think, is relying on the fact that the ring gear is splined to the
ring gear bulkhead and there fore has some minor alignment capabilities.
He also locates the sun gear shaft relative to the output shaft with a
plain bearing. That too should allow a tiny bit of alignment but at the expense
of proper bearing clearances. Also I think Tracy is relying on the extreme accuracy
of modern NC machine tools. So far there are no signs of wear, non symmetrical or
other wise in the prototype after a few hundread hours.

The sketch is my guess of what Tracy's redrive looks like inside.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Tracy-psru-10-2k.gif