Al Gietzen wrote:
On the e-mail list for the the Velocity builders; one of my fellow
Velocity
builders (whom, I believe, is also on this list) posted the following
(what
I may refer to as alarmist BS) in response to an inquiry of a builder
considering a 13B or 20B for his airplane:
------------
........that Mazda rotary engine exhaust heat is all
gathered in one area of the engine, on the bottom of the housing,
exhaust is
ALWAYS happening with very little rest between pulses and rotor housing
sealing is done with O-rings that tend to collapse with age/heat. If a
housing side plate/housing seal ruptures, it is equivalent to loosing
1/2
power output in a normal auto engine conversion. On earlier 13B RX-7,
the
oil
cooler is mounted over the rubber heater hoses. As the engine ages,
cooler
mount O-rings begin leaking and oil soaks the hose. After a while, the
hose
ruptures, coolant literally explodes out of the fitting draining the
housing
and causing an overheat condition so rapidly that the car cannot be
pulled
over to the curb fast enough to save the engine. We get the car in the
service department and all it will do is crank over with no compression
and
spout coolant out of the radiator due to water jacket pressurization. A
complete failure. Unless a catstrophic engine failure occurs in an auto
conversion, about the worse you can expect in an auto conversion would
be a
blown head gasket 86'ing two holes normally.
-------------
Since I would find it difficult to respond objectively; perhaps someone
else
would like to undertake the task.
Al Gietzen
Already did Al. They may not let me post so perhaps someone could forward
my
comments.
Paul Lamar
Tracy Crook wrote:
I won't argue with the admonition to do the best you can with cooling system
design (makes sense to me) but as for the rest, it is contrary to what I and
others have experienced. Ron Gowan had a total coolant loss 40 miles from
closest airport in his rotary powered eze and landed with the engine still
running. It was pretty well trashed but it did get him there. I never had
a coolant loss in my plane but my RX7 burst the exact heater hose that the
message writer mentioned. I drove the car 5 miles home (slowly, with a
couple of stops to let it cool) and the engine did not seem to suffer (I'm
still driving it). This is a far cry from "not beaing able to pull off the
road fast enough to avoid trashing the engine". I agree with Al. The
message was alarmist.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org