Ed Anderson wrote:

I run my 13B with a 26 psi Strand radiator cap and have seen as high

as

21

psi on the gauge.  I also was concerned that the increased coolant

pressure

might cause leaks around the water pump seals, but so far not a

drop.

Ed Anderson

Yvon Cournoyer wrote:

Where did you install the coolant pressure sensor?
Yvon Cournoyer

Yvon,

    I installed the coolant pressure sensor on the header tank where the
radiator cap is also located.  Both are on the intake side between the
radiators and water pump intake.

Ed

Here is a picture of Ed' very fine instrument panel.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org