Subject: In defense of the rotary
From: Paul
Date: 12/5/2000, 10:29 AM


........that Mazda rotary engine exhaust heat is all
gathered in one area of the engine, on the bottom of the housing, exhaust is
ALWAYS happening with very little rest between pulses and rotor housing
sealing is done with O-rings that tend to collapse with age/heat. If a
housing side plate/housing seal ruptures, it is equivalent to loosing 1/2
power output in a normal auto engine conversion. On earlier 13B RX-7, the
oil
cooler is mounted over the rubber heater hoses. As the engine ages, cooler
mount O-rings begin leaking and oil soaks the hose. After a while, the hose
ruptures, coolant literally explodes out of the fitting draining the housing
and causing an overheat condition so rapidly that the car cannot be pulled
over to the curb fast enough to save the engine. We get the car in the
service department and all it will do is crank over with no compression and
spout coolant out of the radiator due to water jacket pressurization. A
complete failure. Unless a catstrophic engine failure occurs in an auto
conversion, about the worse you can expect in an auto conversion would be a
blown head gasket 86'ing two holes normally.



I failed one engine because of coolant loss. The driver didn't notice the temp go to the moon when a piece of the track went through the radiator. We ran a number of laps after that (finished the race) when he came into the pit the engine would not shut down by turning off the ignition switch. I opened the hood and jerked the coil wire off. Still nothing. I had the driver hold the brake and let the clutch out in 5th gear. That stopped it. The distributor was OK. Everything else was junk. It smoked for an hour after that. If you do loose the coolant, forget about "saving the engine" keep your foot in it and get it on the ground ASAP. For this type of failure I would want the rotary up front, not the piston engine.

Lynn E. Hanover

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org