Subject: Low cost compact tangential muffler?
From: Paul
Date: 12/5/2000, 8:13 AM


I notice looking at this picture of Andy's engine installation
he appeared to be using a stock exhaust manifold with side exhaust
pipe. I am almost certain that the stock manifold works somewhat
like a tangential muffler to quiet the exhaust. I have never heard
Andy's engine so I can't be sure. Looks like a good cheap and dirty
muffler solution with a small increase in weight. I would guess the
stock cast iron NA manifold to weigh somewhere between ten and
fifteen pounds.

The exhaust manifold must have lived as Andy had about 450 hours before
he lost oil pressure and the engine seized. It also looks like in this
picture
Andy was using aluminum oil lines for the oil cooler plumbing. A definite
no no and a recipe for disaster. A crack in one of these lines could also
have lost all oil pressure.

Paul Lamar


Tracy Crook wrote:

The stock cast iron exhaust manifold does do a reasonable job of both
quieting and cooling the exhaust on a rotary.  I use one on my test stand
and use a thin wall mild steel exhaust pipe connected to it with no problems
(about 40 hours of high throttle running).  I never considered puting it on
the plane because of the 18 pound weight.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org