Mike, you are not considering changing your engine to a plugs up configuration
are you? :-)

Paul Lamar

  No, but I am planning to build an aluminum oil pan to relocate the sump
further to the rear. The factory pan sump intrudes into the space where the
intake duct for my radiator needs to go. I'm just curious about the sump
dimensions and the materials that Ed used.

  The pan is the last significant piece of engine hardware I have left to
fabricate. Will start on that after I finish my intake which is in progress
now. The intake is very similar to Tracy's though the injectors will be
mounted differently as will the throttle body. Here's an in process
picture. Should have this wrapped up in a week or two.

Mike Wills

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org