Ken Powell wrote:

Paul,
Do you have a high resolution oil flow schematic of the oil
system that you could post?  I have seen it posted here by
someone but could not find it on the CD (I have one of the 1st
CD's so a lot of stuff is not there) or your web page and I
didn't save it to my hard drive.

Thanks,
Ken Powell

David Doshay wrote:

This diagram shows the metered oil going into the carb. Is this just
on the early models? I know that I have oil injection holes in the sides
of my rotor housings which lube the tip seals directly. Is there
something I'm missing about the picture?

David

Yes. I have a later skematic out of the 1993 shop manual but the sneaker net
floppy drive just broke down on my windows scanner machine. Probably be after
xmas before I can get it fixed. I will be going away for about a week and a half
starting on Sunday and the newsletter will shut down again.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org