I got my new boring head installed on my mill and the material came in so
I am getting ready to make the new redrive/mm plate. I have machined an
insert on the lathe with a 3/8 pin for Tracy's redrive plate so I can align it with the
new plate and match drill all the mounting holes. The oil seal that came from Tracy
will have to be replaced. I will rotate Tracy's plate to move
the starter up along side the exhaust side of the engine. Lots of pictures
when I get back from vacation.
When I get the plate done I will using the boring head to cut some holes
in Ken's peripheral port rotor housings.
I also received the 1-1/2 inch dia. 1/8 wall 4130 tubing for the motor
mount cup holders so that will be cut up and shipped off to the welder soon
as well. Keep plugging away.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org