Ed Anderson wrote:
Hi Folks,
Just finished taking the rear housing off my leaking 13B reported
earlier. Sure enough, as suspected, the outer coolant "O" ring was in three
pieces near the leak area. Rest of "O" ring was resting normally in the
groove, but this portion had clearly been pressed between rotor housing and
rear housing (out of the groove) and had been cut in two places.
I bolted the oil pan and intake manifold on as well as using a couple of
bolts and turnbuckle on the injector side of the block to hold the rest of
the stack together while I loosened the rear housing. Looks like that and
the dowels kept the rest of the stack from separating. Of course I have 8
spare stock inner "O" rings but no spare outer "O" rings, so going to make a
trip this PM to local Rotary Rebuilder to see if he has any.
The Hylomar held the stiffer Teflon coated inner coolant "O" ring in the
groove, but for some reason didn't the outer in that area, perhaps not
enough Hylomar.
Just wanted to let you know - suspicions confirmed broken coolant "O"
ring was cause of leak.
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org