Keep the aluminum C channel Ken. I got enough material for two of those
so I have one. Do you have or can borrow a band saw that can cut 1/2 inch
aluminum? A variable speed saber saw would also work with the right
blade,
speed setting and bear fat lube. My neighbor John Lynch has agreed to let
me use his Do-All but I don't want to take advantage of his generosity
by cutting several plates.
Perhaps I can do some of the stuff that requires a mill such as the
oil seal bore and large pilot hole for the starter and you can do the
rest.
All the bolt holes can be matched drilled on a drill press using the
old redrive plate as a pattern.
I can loan you the pilot turning that will align the two plates.
Also if you can talk Tracy into not shipping a redrive plate and giving
you some credit for it I can loan you my old plate to use as a hole
drilling pattern.
BTW did you get your redrive yet?
Also BTW I widened mine out a bit so the overall width of the plate is 27
inches
giving me 29 inches center to center for the rubber bushings. More room
for turbo's or tangential mufflers.
Paul Lamar
Ken Gillanders wrote:
Paul,
Yes I do have a band saw that will handle the 1/2 inch plate. I would
greatly appreciate you milling out the oil seal and the pilot hole for the
starter. I have not received my redrive from Tracy yet, just the EC2 (nice
piece of work). I will call Tracy and see if I can get some credit for the
plate and appreciate borrowing the pilot turning. I would agree with you on
the width, 24" will be a little tight for a turbo (some day). I had my
engine on the mock up platform this week hooked to the firewall and the
water pump is 1/2" above the cowl line when I use the designed thrust line.
I think I'll drop it 3/4" or I will have to modify the top of the pump. How
vital is the trust line? I think I am going to use the stock exhaust
manifold flipped upside down with a stainless exhaust pipe. I understand
that the stock manifold decreases the db's from the exhaust. If I recall
Andy V did not use a muffler, just a straight pipe. I have a lot of room to
work with on the BD4. I have a new respect for anyone that stuffed the 13b
in a RV4! Paul who is your supplier for the AL plate and $?
Sure I'll do the seal bore and starter pilot hole.
I don't think a 3/4 inch lower thrust line will be noticed.
Industrial metals in Burbank CA. They cut it and delivered it for about $96
tax included. I specified 15 inches high but I think that is a bit too high.
Probably 14 inches high would be a better. Thats about 20 pounds of 6061 T6
so $5 a pound is a bit much. or $4 a pound and $20 cutting fee is still a
bit much. You might want to shop around. Tracy bought a whole sheet 4' by 12'
and has a bunch of cut pieces but they are only 13 inches wide by four feet long
which I don't think is wide enough for our purposes. Will know more next
year. Leaving for the holidays on Sunday morning.
The best way to do this is get everybody that is interested together
and buy a whole sheet and have it delivered to the hydro jet cutters.
Lots less wastage and cutting fees. Also we can get real trick with
some fancy shaped weight saving cutouts. The end pieces that support
the rubber bushing can be cut out of the same material at the same time.
I will see if we can organize this next year.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org