> > The best way to do this is get everybody that is interested together
> > and buy a whole sheet and have it delivered to the hydro jet cutters.
> > Lots less wastage and cutting fees. Also we can get real trick with
> > some fancy shaped weight saving cutouts. The end pieces that support
> > the rubber bushing can be cut out of the same material at the same
time.
> > I will see if we can organize this next year.
> >
> > Paul Lamar
-Cliff Manzke wrote:
>
> Paul, I might be able to help you out with the 1/2 inch mounting plates
if
> enough people want them. I deal with Freeberg Industrial here in San
Diego
> for water jet cutting. They did the 20B intake manifold plates for me,
one
> of which I used to fab Al Gietzen's manifold. If the quantity is enough
(
4
> or 5?) then it's best to let Freeberg (or whoever does the cutting) deal
> with the material. They buy it by the truck load right from the mill so
> their price is always better than what we can do. A DXF cad file is the
> best way to handle the profile, including any holes. The seal bore (and
> starter bore?) obviously needs to be cut undersize and then finished on
the
> mill. Bolt holes can be cut to size, or cut undersize and finished with
a
> ream.
>
> For my material need I deal with Industrial Metal Supply in San Diego.
They
> are not the cheapest around unless you go into their showroom and search
> their mountains of rems. Lots of 6061 plate stock for $.99 a pound, 6061
> bar stock for $1.67/lb, 7075 bar stock for $1.79 lb, mild steel tube for
> $.59/lb, etc, etc. Unfortunately, the sizes and quantities of their rem
> selection is always hit-or-miss so you have to go to the showroom and see
> what they have. Otherwise their normal (high) price for 6061 is $2.69/lb
> unless you buy a bunch.
>
> IMS also stocks 4130 and stainless tube, although I'm not sure of the
price.
OK sounds good Cliff. We need to narrow down the exact design although we
might
be able to design it so people can cut it off to the exact width that will
fit
their cowl.
I think that is a branch of the Burbank store. I could not find any rems
big
enough
so I had to pay full pop. At $2.69 a pound they sure charged me a lot
($40)
for cutting
and delivery.
Paul Lamar
Paul,
Since we are building the same plane (KIS) I am very interested in this motor
mount design.
Lyle Hendricks has made many of the metal parts for the KIS, and has a NC
machine and water jet cutting capabilities. Also is familiar with KIS. He
made several of us the retractable steps out of Aluminum, and they are almost
a work of art.
I wonder what his charge would be for banging out some, with precisely
controlled locations for the thrust bearing and the starter location.
His address is
Lyle Hendricks
28130 Ave. Crocker # 308
Valencia, CA 91355
Hendrikmfg@aol.com
Sounds like it is best to get a couple of bids. Since we are going hydra jet
this is my suggestion for some lightening holes. I think it is better cosmetically
too. Looks "trick" as we used to say in racing :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org