Subject: Photo of coolant leak culprit
From: Paul
Date: 12/27/2000, 7:38 AM

Ed Anderson wrote:

Paul,
    Attached is photo of rear housing outer coolant "O" ring that fell out
of its groove during installation of the rear housing and was cut into
several pieces.  Result was coolant leak between rear rotor housing and rear
side housing.  Apparently too little Hylomar or perhaps a spot of oil in the
groove, but it required 7 hours to fix.  Only about 20 minutes to replace
the seal, rest of time was removing/reinstalling engine and getting to the
engine.

Best Regards

Ed


That teflon encapsulated  silicone inner seal still looks in good shape :-)
Perhaps it is worth biting the financial bullet and using those on the outer seal as well.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Ed-Anderson-Coolseal.jpg