Ed Anderson wrote:
Paul,
Attached is photo of rear housing outer coolant "O" ring that fell
out
of its groove during installation of the rear housing and was cut into
several pieces. Result was coolant leak between rear rotor housing and
rear
side housing. Apparently too little Hylomar or perhaps a spot of oil in
the
groove, but it required 7 hours to fix. Only about 20 minutes to
replace
the seal, rest of time was removing/reinstalling engine and getting to
the
engine.
Best Regards
Ed
That teflon encapsulated silicone inner seal still looks in good shape
:-)
Perhaps it is worth biting the financial bullet and using those on the
outer seal as well.
Paul Lamar
I agree, Paul. In fact I tried to find a Teflon coated O ring big enough in
size and could not find any. I found some burna? rings but they were 1/8"
thick which is too large for the outer O ring. I will keep looking.
Yes, the Teflon coated inner ring did not look too bad for the wear {:>).
But even the Teflon coated O rings in the old engine were in the same
condition. So my experience is the Teflon O rings are certainly they way to
go and getting them from McMasters at $9 and some change beats getting them
from Hayes at $25 a pop. If you recall from your visit, I have an 87 block
sitting in the wooden stand that I will get around to rebuilding and intend
to use other than Mazda "O" rings where ever possible.
Ed
I got some of the teflon encapsulated silicone outer rings from All O-rings
but they wanted much more money than McMaster Carr.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org