Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 12/27/2000, 3:15 PM

Paul,
I could open Tracy's file, so I have taken it and used the dimensions for 
bolt circles, etc. to modify it into the motor mount version you have 
sketched.  It is attached for your comments.
Bill Schertz

Tracy, Bill, is hole number seven in the right place?
What is it for?
I think we can cut the height of the 1/2 inch thick 6061 T6 plate down 
to 14 inches if we don't need that hole.

Tracy do the rest of the hole locations look OK.
We are getting ready to cut expensive metal here.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Bill-Schertz-kis-mm-plate.gif