Tracy Crook wrote:

Tracy, Bill, is hole number seven in the right place?
What is it for?
I think we can cut the height of the 1/2 inch thick 6061 T6 plate down
to 14 inches if we don't need that hole.

Tracy do the rest of the hole locations look OK.
We are getting ready to cut expensive metal here.

Paul Lamar

Paul,

Holes 5 & 7 are the old starter mounting holes (if I'm looking at it right)
so neither of them should be needed.  I assume yo udo have mounting holes at
the new starter location.  The drawing is very distorted on my browser so
can't do any formal verification.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com

Can you read the numbers OK? I doubled the size Bill had and that distorted the 
circle for some strange reason. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org