Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 12/28/2000, 5:53 AM


 > Tracy, Bill, is hole number seven in the right place?
 > What is it for?
 > I think we can cut the height of the 1/2 inch thick 6061 T6 plate down
 > to about 14 inches if we don't need that hole.
 >
 > Tracy do the rest of the hole locations look OK.
 > We are getting ready to cut expensive metal here.
 >
 > Paul Lamar
 >

 Ok here is a re-run on that message with Tracy's earlier comments added at
the top.
 Looks like holes number  5 and 7 are old starter mounting holes no longer
 needed there. The starter will be moved up to the exhaust side of the
engine.


 Tracy what is the radius for hole 8? Is 7.085 inch radius correct?

 Anybody speak up if you need one of these. Also specify the center to
center
distance
 needed on the rubber motor mount bushings. We will try to come up
 with a number that will work for most. Looks like mine will be 29 inches
 center to center for my Kis Cruiser with turbo.

 Paul Lamar


Paul,
I don't have my engine yet, so I strictly worked off of Tracy's drawing.

Hole 8 reads " 304 12' 26" (7.085) on Tracy's drawing.

Hole 7 and 5 do look like they could be mounting holes for the starter, but
they are NOT symmetrical around the starter center hole.

I would think my center-to-center distance would be identical to you even
though I am not going turbo, if you are using the original cowl for the KIS

Bill Schertz
Kis Cruiser #4045

OK that's two for 29 inches.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org