Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 12/28/2000, 8:27 PM


Does anyone have any idea what the center to center distance should be for a
Velocity??????

Don

If you use the stock cowl 29 inches center to center should fit as that was 
determined by the stock cowl for a Kis Cruiser with a Lyc O-360 installed.
Since the Velocity cowl will also accept a Lyc O-360 the width should be
roughly the same.

As I recall Tracy's redrive plate should be about 24 inches from the firewall.
The prop flange would be about 10 or 11 inches behind that as the distance 
from the back of the engine to the prop flange is about 14.5 inches on Tracy's
redrive. Measure the inside width of the cowl at that point at about the 
height of the thrust line. Should be well over 29 inches wide.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org