Harley wrote:
Paul...
Did I forget to address anything else?<<
I don't think so, but I think I may have...
I forgot that you guys have tractor applications.
How would this work as a pusher mount? Like on a Long EZ? It looks like in
a pushing configuration it may tend to rotate around the rubber mounts with
attitude changes.
Harley
That is the function of the front mount in the case of a pusher. Rear mount
in the case of a tractor. Those mounts where not installed in my model.
If only one front/rear mount is used the the prop torque on the mount will
be very small and not a problem.
In short this plate should work fine in a pusher.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org