Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 12/29/2000, 10:09 AM


Anybody speak up if you need one of these. Also specify the center to
center  distance
 needed on the rubber motor mount bushings. We will try to come up
 with a number that will work for most. Looks like mine will be 29 inches
 center to center for my Kis Cruiser with turbo.

Paul,
I know I'm way behind the power curve here, but I missed the first part of
the discussion on this mount.  Is this an adapter to fit a lyc mount, or
mounting brackets to fit onto Tracy's plate?

Sorry I missed the first mesages, but it sounds really interesting.

Dave Leonard

It is a combined redrive plate and motor mount bracket. 
A motor mount design based on this plate would look like this model.
The rubber mounts are spread wide apart to:

A: reduce the heat on the rubber motor mounts.

B: transmit less vibration into the airframe from torque variations.

C: relieve Tracy's redrive spacers from higher prop torque reactions. Only 
lower engine torque is transmitted through the spacers. Prop torque is taken
directly by the redrive plate. The spacers can be made lighter.

D: eliminate any other main motor brackets on the engine & reduce the weight. 

C: cutout the cost and time of making main engine mount brackets.

E: allow plenty of room along side the engine for mufflers, turbo chargers,
intake manifolds and water pump plumbing.

F: the downside is longer motor mount tubes about five to ten inches longer.

G: the upside to this is the load on the main mounts is reduced while the
load on the already very lightly loaded rear mount is increased slightly.

Did I forget to address anything else?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org