Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 12/29/2000, 10:57 AM


Anybody speak up if you need one of these. Also specify the center to
center
distance
 needed on the rubber motor mount bushings. We will try to come up
 with a number that will work for most. Looks like mine will be 29 inches
 center to center for my Kis Cruiser with turbo.


I am very interested in making my mount, but I am wondering about the need to
the mount all that way forward, mostly to support something that is further
aft.  Seems like a little wasted weight, complexity, and tubes getting in the
way.

I went and saw Mike Wills' installation the other day.  It sure is looking
nice.  In particular, I think his mounting brackets are elegant, simple,
functional and sturdy.  Here are the pictures.  Mike, I hope you don't mind.

Dave Leonard


Don't forget the weight of the prop Dave when calculating the CG of the
engine/redrive/starter/prop combination. The redrive and starter alone
are about 45 pounds not including the torque vibration damper.
I would guess the CG of the overall combination should be somewhere around 
the joint between the front rotor housing and the front (back in the car) 
endhousing.

These aft mounts  are very nicely made but somewhat overkill in some ways 
for the modest loads. 

Also on the right aft mount I don't see any vertical bracing.
Same goes for the left aft mount. There is some up and down load on these
mounts due to the fact the main front mounts are below the thrust center
line and the engine is going to want to rotate counter clockwise looking at it
from the left side about an axis through the front mounts while generating 
prop thrust. Also the lateral distance between these mounts means that they 
will react some prop torque loads as well along with the main mounts. Look 
for cracks on the bottoms and tops of these tubes back near the firewall.
They may take the bending loads no problem and they may not. A finite element
analysis would be needed to know for sure.

Any rubber mount holder should be located in space by a minimum of three tubes.
Mike needs to make a 1/4 scale balsa model of this overall motor mount design.
If he does that some of these contentions on my part will become obvious
when modest loads are applied.

It is always difficult to critique such fine workmanship.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Mike-Wills-left-aft-mnt.jpg

Mike-Wills-right-aft-mnt.jpg