OK, OK. You're making this too tempting. Put me down for one as well.
Looks like turbo clearance is going to be close and I know that getting the
exhaust forward out of the turbo is going to be a challenge as well. I am
still not convinced that the mounting bolts for the RD2 could handle the
weight of the engine and accessories in 6 g's. Can anyone alleviate my fears
with a calculation? (I'm no engineer).
As far as the aft mounts go, if we were to try to find a single mount in the
center of the back (front) looks like we would have to have new front covers.
I really like Mike's brackets. Sure seems like an easy thing to get now
while we have a run going. So, Perry, count me in for a pair of those too if
you decide to get them done.
Dave Leonard
Right now tracy has a 1/2 plate in there roughly four inches long, four
inches high and 1/2 inch thick with two ten mm bolts top and bottom.
Thetwo ten mmm bolts are spaced about 3.5 inches apart. If you consider
them the flanges on a cantilevered I beam and the aluminum spacer the web we can
calculate the tensile load in the upper bolt.
For the moment lets assume the worst case and this one spacer does all the work.
The bending moment is four inches times 1800 pounds at 6 G's or
10,800 inch pounds. That assumes everything aft of the redrive plate
weighs 300 pounds. So the tensile load in the upper bolt is roughly
3100 pounds. The lower compressive material is supplied by the aluminum
spacer. A 10 mm bolt is roughly .380 inches in diameter so the area
is roughly .113 square inches. So the tensile stress in the upper bolt
is 28,000 psi. Piece of cake for a AN quality or even a 150,000 psi grade five
bolt. The shear load is shared by both upper and lower bolts
so that is even less at about 900 pounds each bolt. This totally
ignores the contribution of the rear motor mount and the other three or
four 10 mm bolts with their spacers.
Not to worry Dave. The engine is not going to fall out of the cowl
even if you drop it in from five or ten feet :-)
This is just one way of estimating the stresses. You could consider the
upper two 10 mmm bolts the upper I beam flange material and the lower two 10 mm
bolts the lower I beam flange material and the whole engine a cantilevered beam with
an overall bending moment of 1800 pounds times ten inches (distance to
the engine CG) or 18,000 inch pounds. The four bolts are spaced
roughly 14 inches apart in this case so that is still not much
load on these bolts. 1290 pounds tensile load for two bolts or
643 pounds per bolt.
The most accurate way would be of course a finite element analysis.
This is a picture of Mike Wills mount showing the spacer in question.
I will eventually replace Tracy's spacers for cosmetic reasons with one
inch dia. drilled aluminum round bar stock and a rolled 3/16 sheet metal flywheel
cover tacked welded to the outside of the spacers.
The aft mount can be a simple contoured 1/2 inch thick horizontal plate to fit the
oil pan bolt pattern at the front cover with a large hole in it for the Barry
rubber bushing. The loads are real low back there. Mine will be off set to one side for
clearance with the nose gear shock strut on the Kis Cruiser. It should
make working on the water pump and v belt drive system easier. My alternator
will reside where Mike Wills right hand rear motor mount now resides.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org