Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 1/2/2001, 1:59 PM


 Not to worry Dave. The engine is not going to fall out of the cowl
 even if you drop it in from five or ten feet :-)


Thanks, Paul.  I do feel a lot better now, and excited about the project.  In
fact, put me down for 2.   :-) (just kidding, one's enough)

BTW, I flew an RV-4 today.  WOW!  (is all I can say)

Dave Leonard

Looks like I got about three eight hour days so far in the prototype.
I cut the holes for the rubber bushing using my boring head on the mill. Overkill
and too tedious. For the life of me I don't know why they don't make boring
heads square with vernier scales. The masking tape and pen mark lets
me know when I get in the ball park. 

A good quality metal cutting 1.25 inch hole saw in the slowed down drill
press would probably be better. Shown is one a bought at Home Depot.

Note: the round end in the slot that fits the redrive plate. Drill 1/2 inch
hole and cut the slot on a band saw. No point in designing in a stress 
concentration with a slot with square corners. Same will be done
on the redrive plate itself.

The edge of the hole holding the rubber bushing must have a radius on 
it according to the Barry instructions so the rubber will not be cut 
by sharp edges. This is best done on a high speed drill press with 
one of those polishing cylinders consisting of a dozen pieces of sand 
paper sticking radial out of the shank.

The hydra cut pieces will come with some of this kind of hand work 
and some small holes to be drilled still to be done.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org