Well our plate is mostly a simple 14 inch diameter (as I recall) so some
accommodation of different hole patterns is possible. Extra unused holes
in the
plate will not hurt. Can you make a drawing
of the auto tranny 13BREWs/20Bs bolt patterns? Just a table of bolt hole
offsets
would be fine. I would settle for a thin piece of aluminum (say .032) with
a transfer
center punched hole pattern from the auto tranny bell housing. I could then
compare it to Tracy's plate.
Paul Lamar
marc wiese wrote:
Let me see what I can do. It may be easier if I just ship you my 3rd gen
auto tranny bellhousing and you can take accurate measurements from it. Let
me check to make sure the auto tranny bellhousing from the 13Brew is
exactly the same as the 20B bolt pattern first. I may also have a spare
rear manual housing around here to check against also.
Marc Wiese
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org