marc wiese wrote:
OK, Paul, you have convinced me that this may be a good idea.
Put me on the list for one. However, if possible, please DON'T cut any of
the starter holes in mine. I will be making other provisions for that.
Marc Wiese
I don't know if we can do that Marc. When we get them Hydra Cut it is done
by computer out of one huge 4' by 12' plate of 1/2 inch thick 6061 T6 aluminum.
You might want to cut your own in a case like that. My leanings
are for the starter to be on a horizontal line through the e-shaft
center line off to the exhaust side. Only minor up and down
repositioning is possible. As I recall the 10 mm mounting bolts
get in the way on the ignition side. The starter in both cases
projects forward along side Tracy's redrive.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org