Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 1/3/2001, 5:10 PM



. All 13B and 20B's
(I think) have the same bell housing bolt pattern so the Universal Motor
Mount Plate
should fit them all.


marc wiese wrote:

Paul,
I can confirm that the above statement is incorrect. All 20Bs had automatic
transmissions; hence used a different rear housing, starter (geared for
auto tranny with brace) arrangement, and bellhousing bolt pattern. All 3rd
gen (1993-01) auto tranny 13BREWs are the same as the 20Bs (with different
rear housing, starter and bellhousing bolt pattern than manual models).
However, many (but not all) of the rear housing bolt locations are the same
as the manual transmission models.
Tracy's RD mount fits only the manual transmission rear housings. If used
on an automatic model housing, some bolts would have to be relocated.
Marc Wiese

Well our plate is mostly a simple 14 inch diameter (as I recall) so some
accommodation of different hole patterns is possible. Extra unused holes in the 
plate will not hurt. Can you make a drawing
of the auto tranny 13BREWs/20Bs bolt patterns? Just a table of bolt hole offsets
would be fine. I would settle for a thin piece of aluminum (say .032) with a transfer
center punched hole pattern from the auto tranny bell housing. I could then 
compare it to Tracy's plate.

Sounds more and more like you need a custom plate.

The three rotor engines built up from 13B parts by Bruce Turretine use
the 13B manual TX rear housing as I recall and I think.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org