David,
I am using Tracy's EFI and I am going to use two high pressure fuel pumps
designed to fit Ford Mustangs. These are 110 litre per hr and are good to
~300 HP each. They have a fine screen on the bottom of the filter to
prevent pump damage. This will allow using only high pressure filters
downstream of the pumps. Also note that the the submerged pump will be
'pushing' fuel rather than 'sucking' fuel, which I understand to be the
preferred method. I have not decided on fuel return, but I am leaning
toward Tracy's KISS system of returning to the same tanks as the pumps. As
usual, low wing aircraft present interesting challenges when dealing with
the fuel systems. I also like Mike Wills system - it is more idiot prove
(can you say 'pilot error' - boy that scares me!) but more complicated
mechanically. Mike uses a return circuit that switches the return to the
active tank.
Ken Powell
kenpowell@aristotle.net
- - - - - - - -
Ken,
Two thoughts:
1) Re Mike Wills system (return fuel to active tank): That is what I am
going to do - using the Andair "duplex" fuel selector, the efi return fuel
goes back to same tank it came from. Only one fuel control selector handle,
just more plumbing when you install the system. NOTE: I am not using a
"header tank"; just feed from L or R tank and let the duplex fuel selector
return fuel to same tank. Another factor is that the fuel flow system has
to have a sensor in the line "to" the engine and in the line "from" the
engine - adds a bit of expense, but not enough to be a factor in my view.
2) About flow (hp) capability of efi fuel pumps: I have never raised this
to either list but do so now. It is my understanding that the efi system
regulates fuel pressure in the injection manifold by bypassing all fuel not
being injected into engine. It is my impression that the fuel pumps run
"full speed, full flow" "all the time". If this is true, then I want to
size my pumps so any single pump will only supply enough fuel for 160hp (or
180 or 220, whatever my design point is), with a bit of excess for the
non-standard days when engine power is higher than "standard", i.e.,
Wisconsin or Canada in the winter when it is zero to 10 degrees F (I
personally don't fly when colder than that due to survival difficulties with
windchill, etc) - engines develop much more power in the cold dense air,
thus much higher fuel flow, so I'll have to have more than "160hp worth" of
fuel flow if I want to be able to operate at Wide Open Throttle (WOT) in the
winter.
- My point, or question, request for validation/peer review is this:
Wouldn't it be better to have "just enough" fuel flow capacity from the efi
pumps, rather than perhaps a great excess? I would think this would tend to
call for smaller, lower amperage pumps, with resultant/relative increase in
"time available from battery" in case of an alternator failure.
David Carter
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org