Subject: width options of the UMM plate
From: Paul
Date: 1/3/2001, 10:31 AM


 That's a good idea Bob. We will keep the lightening holes out of that area
so
 people can cut the plate off to whatever length fits.

 Here is the rubber mount holder installed on the redrive plate.
 This one is a bit narrow at only 1.8 inches wide. Note; a bit of
 rubber hanging over the edge. I think I will make the
 production version 2.25 inches wide for a bit more strength
 and support for squashed rubber.

 Paul Lamar


Paul,
Is the rubber mount holder "keyed" to the motor mount plate with an egg-crate
slot feature?
Bill

Bill Schertz
Kis Cruiser #4045

Yes. I am not good at 3D sketches but I will try. Not to scale.
This interlocking feature takes all the load except a very minor
lateral load when flying sustained knife edges :-)
That is the job of the four (two on each side) 1/4 inch bolts.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

bush-hold-3d.gif