Subject: width options of the UMM plate
From: Paul
Date: 1/3/2001, 1:40 AM

Jeff Spitzer wrote:

BTW, you "narrow" guys might have better luck than the "wide" guys using the
same mounts.  The reason goes like this:  If the engine were hung from a
string and run with no prop, each time it fired it would spin a bit and then
it would spin back the other way during compression and merrily spin back
and forth...with no torsional vibration transmitted through the string.
Lets just say for the sake of argument that the engine would naturally spin
1 degree in each direction while hanging from the string.  When you add
mounts the engine can no longer spin back and forth 'cause the mounts
restrain it.  If the mounts are 30" apart (15" each side) then the 1 degree
motion translates into .26 inches of mount deflection.  The mount wouldn't
actually deflect .26" because it is offering some resistance but lets say
the mount does anyway.  At 1000 lb/in that would be 260 lbs transmitted to
the airframe.  If the mounts were at 15" total (7.5" per side) then the
deflection would be half and the load transmitted to the fuse would be half.
This is kinda a bad example of a valid point.  Not to worry for the wide
guys...they just need to use softer mounts than the narrow guys.

Jeff Spitzer

I am a bit surprised Jeff. The torque pulse is constant and the mount "spring"
rates are the same the angle of deflection will be half with the wide mounts
as the torque pulse load on the wide mounts is half. Don't forget the 
deflection due to static weight. Also these rubber mounts are not linear 
and have a rising rate. Half the torque pulse load means they are more nearly 
operating in the linear region.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org