Subject: A new interesting 100 HP VW based engine.
From: Paul
Date: 1/4/2001, 12:30 PM
CC: Kis Newsletter



I get readers from time to time looking for a light weight low cost 100 HP
engine.
A 100 HP one rotor Mazda rotary is too heavy.

http://www.pulsaraircraft.com

The weight of the Aeromax engine is listed as 165 pounds. That is highly
unlikely. That sounds like the weight of the core VW engine alone, less the
gear box. The "Built in elastic harmonic ** balancer **." I think he is
talking about
is an elastic torsional isolator or torsional damper and not a "balancer".

Most likely a torsional damper. I guess I need to see this engine to be
sure.

Interesting engine. Not a bad power to weight ratio even including 30
pounds
or so for the gear box. Right down there with the weight of an O-200.
About time somebody put a prop reduction gear box on a VW and ran it faster
for more power. Overhaul parts should be real cheap indeed. Now if you
can get the exhaust valves to cool should be a pretty good engine.
I wonder if the gear box is available separately?

Paul Lamar


Stone Tool wrote:

Paul:
    A bare type one engine without mag, exhaust, intake, or oil cooler
weighs in about 120 lbs.

    Great Plains lists the type 4 2400 cc engine as 85 hp and lists the weight
as 188 lbs including the Diehl accessory case.    The Type one engines range
from 160 to 165 in the same configuration.

    While it is possible to get 100 horses from a VW they will not hold
up..... this has been shown time and again.    Bob Hoover who has worked
with these engines for many years has determined that the maximum sustained
horsepower you can get out of either the type 1 or type 4 is about 50 due to
limited cooling capacity of the head design.   After that the exhaust valves
are going to give trouble.    There will always be those who claim great
horsepower, or believe that they are immune to the laws of
thermodynamics...........   I'm not one of them.   I recollect awhile back
some company claiming 150 horses from a naturally aspirated Subaru EA
81...... My calculations show that about 9000 RPM would be
required..........    It's a pretty engine but their claims are highly
questionable both in weight and power.

                                        H.W.

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org