Leon Promet wrote:
HI Paul,
See comments below marked ##
OK Leon I guess my 25 year old memory was fuzzy.
I think I see what is going on here.. finally. The ones I was referring to
went near the combustion chamber in the old days.
##
Never! I was under that very misunderstanding back in the early ' 70s
until my mentor cracked me across the knuckles!
I did not mean on the combustion chamber side of the O-ring in this statement.
I meant on the spark plug side of the engine and not the exhaust side.
We are talking of two different styles of protectors here.
See the scan out of the Glenn manual below. PL
Apparently those are no longer used.
##
Well sort of correct. They are not used on "86 ~ on motors that have the
grooves in the cast housings. However, I still use them (and so should
anybody else) if I am assembling any "85 or EARLIER engine which has the
grooves in the aluminium rotor housing. I still do quite a few 10A twin
distributor Peripheral Port engines (I have two on the trot now for a mate
who races in Club Motorsport) as well as 12A & 13B engines.
I just checked the Haynes manual for 1986 through 1991 and they are used
adjacent
to the *** exhaust port *** on the outside of the o-ring??
##
Well, sort of! The correct position is to run them from just below the
exhaust port around the *hot* side of the motor past the spark plugs.
They go on the water jacket side of, and concave side facing the INNER "O"
Ring! See my previous post. All the details are there. I know it's long,
but anybody who is going to build an early model engine needs to know the
truth (It is not subject to any private interpretation, nor is it a matter
of opinion!). Mazda knows. If you are building a '86 ~ onwards engine,
FORGET you ever heard about this, it does NOT apply!!
However the picture,
page 28, in the Haynes manual shows them adjacent to the intake port near
the
inner O ring. The Haynes manual also does not say inner or outer o ring.
Just says
"outside the O ring". I will scan this picture soon. More on this when I
get a bit
more time.
##
This is the problem with a lot of after-market manuals. Mis-information,
or just plain wrong. I only ever use factory manuals. Sure they are
dear as poison, but you only ever get what you pay for!. Anyway, every
Genuine Mazda "O" Ring kit has a diagram of EXACTLY how to use them. Next
time I open a packet, I will get it scanned and post it. Forget what the
Haynes manual says or doesn't say. Mazda knows.
These pieces are not mentioned at all in the 1994 official Mazda Work shop
Manual.
I guess they are not that important and are no longer used. Perhaps they
changed the groove dimensions or the size of the O-rings.
##
Again Correct. The grooves are deeper, and the "O Rings are also *fatter".
See what I wrote in my previous post. All is explained there. It is not
that the *Protector Strips* are NOT important, they are actually
beneficial in '85 and EARLIER engines. Mazda just used them as a fix of a
bad design problem. In the '86~ onwards motors, the redesign and new
tooling removed the necessity.
I am getting old and sometimes forgetful but I can still remember these things
from 25 years ago. Here is a scan out of Glenn's 1974 Tune Up and Repair Guide.
Best rotary engine book ever published including the factory manuals which I have
several of. My first rotary was a brand new 1973 RX2.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org