Subject: Universal motor mount plate for Tracy's redrive?
From: Paul
Date: 1/4/2001, 4:35 PM


Let me see what I can do. It may be easier if I just ship you my 3rd gen
auto tranny bellhousing and you can take accurate measurements from it. Let
me check to make sure the auto tranny bellhousing from the 13Brew is
exactly the same as the 20B bolt pattern first. I may also have a spare
rear manual housing around here to check against also.


marc wiese wrote:

Well, no manual rear housing. Must have used it up when I built up the 91nt
engine for the 5 sp convertible. Anybody need a spare f13B  pre 89, I think
(non recessed drilled ring around the oil gallery passage to front
cover)  front end housing?
There are 6 threaded bolt holes in the 20B/13Brew auto rear end
housing/bellhousing. 2 are doweled (1:00 and 7:00 oclock approx). All have
threads. The auto tranny bellhousing has another hole position cast in, but
it is neither drilled thru nor is there a place for it to mate to on the
end housing  of either the 13Brew [from which it came], nor on the 20B (it
is at the approx 2:30 o'clock position as viewed from rear of engine).
Looks like I will have to custom make my plate. Where did you get your slab
of al for that?
Marc Wiese

Industrial Metals in Burbank CA.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org