Subject: Correction-Heat Strips Take 3 : Final Solution!! |:>)
From: Paul
Date: 1/5/2001, 9:08 AM

Leon Promet wrote:

Hi Paul,

Having looked at the Gif you attached,  it looks absolutely identical,
 (except for being redrawn, with the top right hand quadrant being added),
to what is printed on the sheet that accompanies every genuine Mazda  0845
and 1757 "O" Ring kits.  It is absolutely correct.  You will notice  the
drawing in the bottom left quadrant shows the concave side of the protector
on the water side of the INNER "O" Ring and AWAY from the combustion side.
 I think that is what I said in my previous email?

 And I Quote:

*******The correct position is to run them from just below the  exhaust
port around the *hot* side of the motor past the spark plugs.  They go on
the water jacket side of,  and concave side facing the INNER "O"  Ring!
*****

End Quote

The strips are actually a lot longer than what the drawing shows. They are
actually long enough to go from the bottom of the exhaust port right up
past the plugs to that top dowel. Because of this I have always taught
people to start at the  bottom lip of the exhaust port, but it is equally
valid to start at the top dowel hole.  As we say over here in OZ,
 "Duzzenmadda!"

As long as the strips cover the *hot* area above and below the plugs,  and
are on the water side of the INNER "O" Ring,  and the concave side faces
the "O" Ring. (Oh shut up Leon, get off the cucumber,  you are beginning to
repeat yourself too much. You are becoming exceedingly tedious!!).

The Gif is therefore correct.  It tallies exactly with what Mazda says.  It
also tallies with what I said that Mazda say.  A it would therefore seem
that we are now in absolutely total & violent AGREEMENT,  I think this
should finally put this issue to bed!  TETALESTAI!

Cheers mate,

Leon


Thanks Leon. Since some of us are using teflon encapsulated silicone O-rings
(me among them) and very few of the rest of us are aware of these things
(as far as I can tell) and  have obviously built engines with out them I 
think this issue is becoming academic. I was beginning to think I drank
too much EggNog for Christmas :-) I have disassembled a couple of 2nd
gen engines and not found the strips.

What has come to light over all this is the fact that Mazda  apparently 
changed the slot size in the 1993 and later engines.

Now I would like to know the dimensions of the O ring slots in the 93 and later
end and intermediate housings as this could be an issue with the proper
size of the teflon encapsulated silicone O-rings. The second gen 
center housing I have sitting in my office is .13x inches wide by .07x
inches deep. I have no way of knowing if this cover has been lapped
but in any event only several thou (x) is usually removed by lapping.

The outer slots are the same dimensions. This to me looks like it calls
for a 3/32 (.0938) section O ring and as I recall Ed Anderson came up with the
same section size.

So please if anyone has a 1993 or later engine please measure the slots.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org