Subject: Correction-Heat Strips Take 3 : Final Solution!! |:>)
From: Paul
Date: 1/5/2001, 12:38 PM



Thanks Leon. Since some of us are using teflon encapsulated silicone
O-rings
(me among them) and very few of the rest of us are aware of these things
(as far as I can tell) and  have obviously built engines with out them I
think this issue is becoming academic. I was beginning to think I drank
too much EggNog for Christmas :-) I have disassembled a couple of 2nd
gen engines and not found the strips.

What has come to light over all this is the fact that Mazda  apparently
changed the slot size in the 1993 and later engines.

Now I would like to know the dimensions of the O ring slots in the 93 and
later
end and intermediate housings as this could be an issue with the proper
size of the teflon encapsulated silicone O-rings. The second gen
center housing I have sitting in my office is .13x inches wide by .07x
inches deep. I have no way of knowing if this cover has been lapped
but in any event only several thou (x) is usually removed by lapping.

The outer slots are the same dimensions. This to me looks like it calls
for a 3/32 (.0938) section O ring and as I recall Ed Anderson came up with
the
same section size.

So please if anyone has a 1993 or later engine please measure the slots.

Paul Lamar


Cliff Manzke wrote:
Paul, a 3/32" O-ring has a cross section of .103/.104, so putting that size
in a groove .070 deep is just too much squeeze.  I'll bet the O-rings are
meant to be metric, in which case a 2mm (.079" section) in a .070 groove
would be just about right (~10% squeeze).  I'm no rotary expert but I would
have another look at this.  What do the Mazda supplied O-rings measure?

Cliff Manzke

Darn I don't have the TES O-rings here so I cannot confirm that for the TES
O-rings that I have.  They are up at the hangar. In any event Creavey lists
0.077, 0.080, 0.093 and 0.098 plus or minus 0.005.  

OK Creavey also lists "Universal Cross Sections" 
0.103 which seems about what Ed is using. That must be what is referred to as 3/32
when ordered from McMaster Carr. In any event the 3/32 are working fine for
Ed and he says they are exactly the same size as the Hayes O-ring which Hayes
has been selling for well over a year.

Perhaps we need to order the smaller section sizes and try them. Might be easier to
get them to stay in the groove during assembly as Ed has reported trouble with this.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org