Stone Tool wrote:
Pretty ........
Where are you routing the ports? I really think one of the important
improvements would be integrating head and cylinder into one casting. It
is considerably more difficult than one might imagine casting many thin
fins..... the reason for the P&W sawn fins. On a VW head this would
represent some problems. there are actually fins that go completely around
the valve guides. The solution would of course be to saw the fins right
through the guide area and press the guide in afterwards.... an aluminum
piece with an iron liner.
Virtually all manufacturers of gas truck engines (real trucks, not
pickups which seem to be refered to as trucks these days) used sodium
valves...... these would be the exhaust valves to use.... most of these are
fairly small diameter valves with huge stems.
In any case making a VW head would be no simple project. I would be
inclined to build cylinder & head assemblies together as I previously said,
but perhaps make each one individual and design them to mate and bolt
together at the head for rigidity..... perhaps lower on the jug as well. A
bit of stiffening cannot hurt... these are pretty flexible engines.
H.W.
Same as stock more or less. There are of course a lot more details to be
worked out. I think it could be machined out of a billet. Two cylinders per
billet. A lot of porting done now-a-days is done with 3D NC mills.
BTW Klause broke a J&E piston pin, of all things on one of his souped up O-200's.
You can't go around souping up aircraft engines and expect them to go to TBO.
They are very precisely designed overall to do what they are supposed to do.
Change one part and everything else is screwed up.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org