SNIP
Stone Tool wrote:
Sodium valves do indeed require larger guides...... When you are talking
about replaceable guides this isn't really much of a problem. I do know
that some engines did use sodium valves..... I've seen the exploded
valves...... after failure. They required replacement every 50K I
believe. I don't know what model engines these were, but they did exist.
H.W.
Bill Freeman wrote:
Interesting. I cut a few open over the last 35 years that were "guarenteed"
to be sodium filled. All were solid. I've seen many, many failed VW exhaust
valves, all were solid. If you had to replace them at 50 K, they were about
1/2 as good as the std valves - what is the point? Std solid VW factory
exhaust valves (ATE mfg) would make 100K every time --- IF, IF, IF you adjust
the valve clearance every 3000 miles as required by the factory service
schedule.
This was *absolutely* critical and seldom followed; many VWs (Type 1,2 & 3)
dropped an exhaust valve at about 50K miles due to not adjusting the
valve clearances. The engine moved around and the clearances changed,
if the clearance got too tight, the valve stayed on the seat too short a time
and overheated, then broke. The experiment has been repeated thousands
of times with the identical results. I have rebuilt over 60 sets of VW
heads since
the middle 60s. Built three aircraft conversions two or three years ago for
the WW I Neuport scale replica builders here in town, and reworked the heads for
a friend's Q2 with the Revmaster VW conversion, but I don't fool with them much
anymore.
I wonder if the sodium filled valves could have been in the Type 4 motors used
in the 914 and the very late Vans? Totally different motor, no parts
interchange
with the Type 1, 2 & 3 "regular" motors and very few aftermarket parts
available.
I never worked on these much, and never overhauled one.
If you want a reliable 100 HP "VW" all you have to do is replace the case
with the aftermarket aluminum case, get a forged long stroke counterweighted
aftermarket crank, aftermarket Chevy stroker rods, a set of forged Nikasil
pistons
& cylinders from a Porsche 911, use the aftermarket large port & valve heads, a
Melling cast iron oversized oil pump, an aftermarket electronic ignition
system,
Tracy's fuel injection and find a reliable PSRU that will fit.
Should cost about $5-6K and weigh about 225 lbs. Or buy a used O-200
from a wrecked C150. . . . . . but I gues that wouldn't be as much fun.
Anyone happen to know "what ever happened to" Ken Rand of
the KR1 and KR2 VW powered homebuilt fame?
Bill
It would be cheaper to overhaul than the O-200 Bill.
I checked in Trade A Plane. An overhauled O-200 is going for $11.5K outright.
Part prices are high. $67 for an O-200 exhaust valve.
I thought he ran out of gas. Did the engine fail?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org