Subject: C L Smale rotary powered airplane.
From: Paul
Date: 1/8/2001, 7:50 AM

Wrathall Mark wrote:

C.L Smale wrote>Second  I would change the output shaft. I would make the
output shaft a hollow tube the diameter of the SAE flange.

Mark wrote,
Thanks you for the detailed description. Could you please provide a sketch
of your improved PRSU design. I tried to sketch up the output shaft, and can
see merit in the simplicity, but can't think of a good way to retain the
internal rear bearing on the inner race and it's oil at the same time. You
could retain it with a circlip inserted from the the front of the shaft, but
then sealing it would be a pain. Maybe it would be easier to handle the
thrust loads with a  ball bearing forward, and just use a roller internally
at the rear, retaing it with an interference fit??

Paul, should we attach both .DWG and .GIF files? Sorry I haven't annotated
the sketch, but IntelliCAD (and I) have a problem with the german speaking
world exchange of dots and commas (they have a decimal comma). You enter a
dimension in intelliCAD with a dot (otherwise it won't be read) then it gets
converted to a comma, and sometimes works, sometimes doesn't. AutoCAD 14 is
better there, as it doesn't integrate with windows so closely, so you are
staying in one system.


As long as the drawing file is say less than 50K no problem sending both. If it is over
50K it is wise to send it with a separate message. If it is much over 100K
it should be zipped. I can do that for you. This rule mainly applies to me when
publishing attachments. As long as you send me an attachment less than about 500K
I can usually handle breaking it up into smaller pieces. 

In the case of C.L.'s airplane the first large picture slipped
by my notice. It was over 300K and some ISP's and browser settings will reject that.
If somebody did not get the picture let me know and I will re-send it as three
smaller pictures.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Mark-Wrathal-SAE_flange__output_shaft.gif