Subject: Why not a one rotor?
From: Paul
Date: 1/8/2001, 8:01 AM


Leon Promet wrote:

Hi Paul,

Read your last post as well about lightweight end housings.  Sounds like an
idea that could be promising.  Just like a piston sleeve!  Coolant flow
would be critical to prevent the steel plate emulating a Belleville washer
though.  Would need to have bosses on the other side to bolt it onto the
aluminium to minimise buckling.  Nice idea to set an idiot like me
dreaming!!

Anyway,  so why can't we get more than 75 to 85 neddies out of a single
rotor?  I believe it's 2001,  not 1981!  A stock 13B out of the factory in
1974,  cluttered with all the pollution gear, reactor box, air pump, points
distributor, 9.4:1 rotors and a carburettor was producing 135 BHP.  Does 25
years of development, 9.7:1 rotors, trick 3D Engine Management Systems and
fuel injection etc, not to mention (mild or bridge) porting  them and
removing all the statutory pollution impedimenta only add another 17.5 BHP
per rotor?

Finally,  just been and had a look at the posts of C L Smale's new plane.
  Wonderful stuff.  This is what makes it worthwhile coming here.  Top
stuff C L!!

Sincerely,

Leon Promet

Forgot to give you an answer on this. IMHO we have self imposed a 6000 RPM limit
on our engines mainly because of the 2:1 gear box ratio. If we went to a
3:1 gear box ratio we could use a new side port engine... 280 HP at 9000 RPM
or 140 HP in one rotor form. Many of us also think cruising the engine at
over 6000 RPM is not wise.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org